Anchor NAVI-TRAC LITE PAVILLION - 12 TO 24 Bedienungsanleitung

EVANSVILLE, INDIANAQuality, Craftsmanship and Service since 1892Please read all assembly / installation instructions before the installation or remova

10Front EaveRafterFigure 4bLonger PinUpright Rear Upper SpliceGable End Mid EaveEave ProjectionFigure 4cFrame attaching bracket.Step 4 - Joining Beam

Step 5 - Fabric Mid InstallationWith one installer at top of each rafter, feed eave end of kedar into top channel opening of ridge weldment and down i

12Step 6 - Fabric Ends InstallationWith one installer at top of the end rafter, feed eave end of kedar into top chan-nel opening of ridge weldment and

Step 7 - Fabric TensioningAt back of pavilion, snap buckles of back-end straps to corresponding buckles at bottom of mids. Insert bottom hook into sl

Frame Attaching BracketU-Shaped stabilizer may not be used at corner uprights due to fabric interference.Connection to existing building must be deter

Notes:15

Anchor products are of superior design and operate best within the parameters of these instructions. It is imperative that the instructions be carefu

NAVI-TRAC LT PAVILION INSTALLATION SAFETY GUIDELINESYour own installation techniques will evolve to fit the varied needs of your clients, the experien

3NAVI-TRAC LT/CS PAVILION INV 10X20 10X10 12X20 12X10 14X20 14X10 16X20 16X10 18X20 18X10 20X20 20X10 22X20 22X10 24X20 24X10COMPONENT DESCRIPTION # M

RAFTER “X” CABLEEYE NUT AND BOLTRIDGERAFTER BRACEPURLINTENSIONING TUBE SPLICETENSIONING TUBEEAVE/PROJECTION (NUMBER DENOTES PROJECTION SIZE)EAVEUPRIG

RS-225RAFTER BRACE ONLY ON 20’ OR MORE PRO-JECTION FRAMES.NOTE: 24’ PROJ. HAS EAVE PROJECTION AND EAVE SPLICE PROJECTIONASSEMBLED FRAME ILLUSTRATIONS

Directions for Squaring the Tent(see the diagram above)1. Locate the four primary corners.a. Using a tape measure, mark Points A & B (the width

7Step 1 - Parts LayoutFollow the directions on the previ-ous page for squaring and marking for the frame.Lay out the parts neatly in their ap-proximat

Step 3 - Raising the Beam ArchesRaise fi rst beam. Tie off securely or hold up using adequate installation personnel. Note: There are no stakes or g

9Before placing frame in fi nal position, attach frame attaching bracket to upright rear upper splice on each rear upright.Remove stablizer plate, wash