Anchor NAVI-TRAC LITE 30 WIDE Bedienungsanleitung

Please read all assembly / installation instructions before the installation or removal of this product.1100 Burch Dr., Evansville, IN 47725 Ph. 812

10Using the method shown, you should be able to install the NAVI-TRAC LT using only one NAVI-TRAC JACK. You will lift one side of the Hip End and ins

11Attach the curved, hook ends of two drop-in Purlins (P-15) to the purlin bracket of the standing beam as shown.Using the long Eave Bar Cradle, lift

12To install the hip end fabric panel, first install the Fabric guide bracket on one side of the hip end cross beam, with the wheeled guide facing tow

13INSTALLING THE MID PANELSTo install the mid panel, first attach Fabric Guide Brackets to both beams of the middle bay with the guide wheel assemblie

14FABRIC TENSIONINGAdjacent top fabric panels are tensioned together at each upright (leg) of the tent. As shown at the right, the tension straps

15APPENDIX #1(GABLED-HIP) AND (GABLED-GABLED) END UNITSGABLED-HIP END FRAMEIn the Hip-Gable construction, the hip end should be built first to provide

16Gabled End Frame Assembly If the End Uprights were not installed while the end beam was on the ground, they will have to be installed from a ladder

5354Installation of Gabled End Fabric PanelsTo install the gabled end fabric, first insert one of the wheeled panel guides and bracket on the end beam

APPENDIX #230’ NAVI-TRAC LT CLEARSPAN10’60’30’30’10’70’59 60SINGLE OPPOSING CABLES ON OPPOSITE SIDES OF BOTH END BAYS.X-CABLED BAY FOR EACH ADDITIONAL

ASSEMBLY OF 30’ NAVI-TRAC CLEARSPAN (CS) UNITSNAVI-TRAC LT Clearspan (CS) units are installed with the same procedure as the Gabled-Gabled End style p

Table of ContentsPreparationIntroduction to Navi-Trac LT, Gabled LT, and Clearspan (CS)... 3Component Illustrations...

Anchor products are of superior design and operate best within the parameters of these instructions. It is imperative that the instructions be care

INTRODUCTIONThe NAVI-TRAC LT can be configured as a Hip End, Gabled End, Hex End or Clearspan unit, as described below:30’ NAVI-TRAC LT HIP END UNITS

4UPRIGHT 8’ (U-8)(SEE PART LISTS ON PG #5 AND APPENDICES 1 AND 2)EAVE WELDMENT(EW)GABLED END WELDMENT “L” (GWL)GABLED END WELDMENT “R” (GWR)CORNER

5E-15RG-15R-30RH-30H-30P-15RBU-8U-8BACWEWRW30’ NAVI-TRAC LT FRAME TERMINOLOGY3BAX8-15XR-15REQUIRED ONLY ON UNITS 60 FT OR MORE IN LENGTHCOMPONENT CHAR

NAVI-TRAC LT INSTALLATION SAFETY GUIDELINESYour own installation techniques will evolve to fit the varied needs of your clients, the experience level

7STAKE-OUT DISTANCE = UPRIGHT HEIGHTWEB GUY - STAKING GUIDELINESREQUIRED DISTANCE OUT BETWEEN FRAME UPRIGHTS AND STAKE LINE IS EQUAL TO THE UPRIGHT HE

8ASSEMBLING THE CROSS BEAMBegin the hip end installation by assembling the cross-beam sec-tion of the hip end framing with the eave bars connected, (s

9COMPLETING THE HIP END UPPER FRAMEIn the following steps the upper frame of the hip end will be completed (see fig.13 to the right). Following this