Anchor MESH POOL COVER GROUND TUBES AND STAKES Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Zubehör fürs Wasser Anchor MESH POOL COVER GROUND TUBES AND STAKES herunter. Anchor MESH POOL COVER GROUND TUBES AND STAKES User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 2
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
GTP 0811
INSTALLATION INSTRUCTIONS FOR
EC4415
GROUND TUBES AND STAKES
Water in pool
Pool Cover
Ground tube
Water in pool
Water in pool
Do not angle pool cover ties or springs down to
soil level. Spring or Tie may y off. Soil must
be built-up to deck of pool level.
Always place stake or ground tube as close to
pool deck as possible.
Pool Deck
Pavers
Setting
Bed
Pool Deck
Pool Deck
Earth
Pavers. Drill 1” diameter hole thru paver for
ground tube. Drill 1/2” diameter hole for stake.
Top of ground tube must be ush w/top of
paver. IMPORTANT: Do not install Ground
tube in rst row of pavers adjacent to pool.
Figure 1
Figure 2
Figure 3
Figure 4
Top of ground tube must be flush
with top of ground.
Stake
Top of stake must not be more
than 3/4” above top of ground.
Pool Cover
Spring or tie
Spring or tie
Ground tube
Earth
Earth
Spring or tie
Important: Consult paver
manufacturer for drilling
recommendations.
Pool Deck
Inspect Site!
Caution:
1. Consult your local utility locator service or the
National Utility Locating Contractors Association
(NULCA) prior to installation.
2. Consult design information on pool for plumb-
ing/electrical line placement.
1. For each installation the installer is solely
responsible for evaluating the site and determin-
ing the proper method and equipment to secure
the cover. Some soils require different staking or
securing than that provided with the pool cover.
Due to this variety of soil conditions, the installer
must insure proper anchoring at each anchor
point.
2. This instruction sheet must be used along
with the pool cover installation instruction manual
included with your pool cover.
3. The soil at the installation site of each stake/
ground tube must be capable of allowing the
cover to support the minimum loads of ASTM
F-1346 after installation.
4. Testing of soil conditions and responsibility for
load veri cation is solely the responsibility of the
installer.
One ground tube per tie or spring.
GROUND TUBE IN SOIL
STAKE IN SOIL
GROUND TUBE THRU PAVERS
1’-3”
One stake per tie or spring.
1’-5”
9”
Pool Cover
Seitenansicht 0
1 2

Inhaltsverzeichnis

Seite 1 - GROUND TUBES AND STAKES

GTP 0811INSTALLATION INSTRUCTIONS FOREC4415GROUND TUBES AND STAKESWater in poolPool CoverGround tubeWater in poolWater in poolDo not angle pool cover

Seite 2 - 812.867.2421

1. Remove Brass Anchor screw from Brass Anchor.2. Place Brass Anchor into Counterbored end of Ground Tube.3. Stand Ground Tube up on Firm Surface.

Kommentare zu diesen Handbüchern

Keine Kommentare