Anchor CLASSIC SOLID SAFETY POOL COVER GROMMET SETTING Bedienungsanleitung PDF herunterladen

INSTALLATION INSTRUCTIONS FOR

POOL COVER GROMMETS

Important Note: Anchor Industries has shipped this pool cover without Grommets. The installer is

responsible for insuring that grommet installation follows the guidelines on this sheet so that the

pool cover meets ASTM F-1346.

GS 0810EC4223

PLACEMENT GUIDELINES

90º OUTSIDE CORNER

DETAIL

NON-90° OUTSIDE

CORNER DETAIL

SINGLE GROMMET ADDITION

MULTIPLE GROMMET ADDITION

Placement Notes:

Grommets shall be spaced 2’-0” apart.

Stop and start the 2’-0” spacing at outside corners

Between 1st and Last grommets or between grommet and

outside corner, spacing shall be 1’-0” minimum to 3’-0” maxi-

mum.

The next grommet around from an inside corner shall be the

remainder of the 2’-0” before the inside corner.

When distance is over the maximum 3’-0”, place a grommet

at center between grommet and corner or next grommet.

See details on this sheet for curves.

For irregular shaped covers, start at a logical point (corner, or

approximate center-line.)

1 2

INSTALLATION INSTRUCTIONS FOR POOL COVER GROMMETSImportant Note: Anchor Industries has shipped this pool cover without Grommets. The installer is r

Grommet Setting KitCutterDie BottomDie TopPlace cutting block under mark. Place cutter over mark (between stitch lines) and strike with mallet to cut

Keine Kommentare

Anchor CLASSIC SOLID SAFETY POOL COVER GROMMET SETTING Bedienungsanleitung